The term ?dissipation loss? are available in the info sheet for a pressure sensor or pressure transmitter. One needs this specification to become able to protect the pressure sensor from overheating.
If Have You Heard is operated in a hot environment, it can be necessary to limit its electrical energy. If one neglects this aspect, one possibly risks an overheating sufficient reason for this, in the worst case, a complete failure of the instrument. So how can the correct electrical connection be managed?
Determination of the right electrical connection on the basis of the dissipation loss
First, the maximum permissible electrical energy for the pressure sensor should be known. That is given in the data sheet because the dissipation loss. Please be aware that the dissipation loss can be dependent upon the maximum expected operating temperature of the instrument and should be calculated where necessary.
If the allowable dissipation loss has been determined correctly, then the actual maximum electrical power for the pressure sensor occurring can be determined. The determination can be carried out expediently in two steps:
1. Determination of the voltage at the pressure transmitter using the following formula:
UPressure transmitter = UVoltage source ? RLoad � Imax. Current supply
2. Calculation of the utmost electrical power for the pressure transmitter through the next equation:
PPressure transmitter = UPressure transmitter � Imax. Current supply
The maximum electrical energy for the pressure transmitter (PPressure transmitter), which is now known, must be smaller compared to the permissible dissipation loss. If this is actually the case, both the power (UVoltage source) and the strain (RLoad) were properly calculated and the electrical power of the pressure sensor will undoubtedly be within the permissible range under all operating conditions. Consequently, the pressure transmitter will not heat too strongly and can withstand the mandatory operating temperatures.
Note
In the event you need any advice, your contact will gladly assist you to.

Leave a Reply